What is the primary indicator of over polished connectors?
Primarily, the indicator of over polished connectors is poor repeat ability in measurements of the return loss and insertion loss. For the majority of “spring loaded ferrule connectors” e.g.; LC, SC, MU, FC.
READ THE FULL BLOG ARTICLE HERE: “How can I tell I have over-polished a connector?“ asked more often than you might think…
Answered by AskFOC Technical Team June 21, 2018
Have a technical question for Fiber Optic Center?
Please email your question to AskFOC@focenter.com and we will respond ASAP.
In addition to replying, we will post your question and our answer here on the AskFOC page. Everyone remains anonymous when we post so feel comfortable asking your questions. You can also search to see if your question has already been answered in the FAQs section below.
- Fiber Optic Center AskFOC: Is there a real need for 3D printing polishing film beyond sandpaper? - September 25, 2018
- Fiber Optic Center AskFOC: how many categories are there for buffered fibers? - September 25, 2018
- FOC Tips: fiber stripping blades - September 24, 2018
- Fiber Optic Center AskFOC: where can I get some information on SMA connector over polishing? - September 21, 2018
- FOC Tips: SMA High Power application - September 20, 2018
- Fiber Optic Center AskFOC: which epoxies cause allergic reactions and which do not? - September 19, 2018
- FOC Tips: solutions for clean connections - September 17, 2018
- Fiber Optic Center AskFOC: how can I identify crystallization in epoxies? - September 14, 2018
- FOC Tips: Step one of single-fiber PC ferrules, developing a polishing process - September 13, 2018
- Fiber Optic Center AskFOC: what happens if you undermix epoxy? - September 11, 2018