What are the differences between Silicon Carbide, Diamond, and Final in Lapping Films?
Silicon Carbide is typically used for epoxy removal, Diamond is used to recover or form the Radius of Curvature and Apex Offset, and the final film gives the end-face its shine and affects the fiber height. The lot to lot consistency of these films must be spot on to give consistent results.
READ THE FULL BLOG ARTICLE HERE: Do you want consistent polishing processes? Well let’s start with the polishing film
Answered by AskFOC Technical Team July 23, 2018
Have a technical question for Fiber Optic Center?
Please email your question to AskFOC@focenter.com and we will respond ASAP.
In addition to replying, we will post your question and our answer here on the AskFOC page. Everyone remains anonymous when we post so feel comfortable asking your questions. You can also search to see if your question has already been answered in the FAQs section below.
- Fiber Optic Center AskFOC: do you have epoxy information in the form of a matrix? - June 17, 2019
- FOC Tips: to investigate core cracking issues and identify the cause - June 13, 2019
- Fiber Optic Center AskFOC: how much water should we use when polishing? - June 12, 2019
- Fiber Optic Center AskFOC: Can you give more detail about the bend test? - June 11, 2019
- FOC Tips: the “golden rule” in stripping - June 11, 2019
- Fiber Optic Center AskFOC: why do we need to consider the Tg when selecting an epoxy? - June 10, 2019
- The Best Laid Plans of Mountains and Men: Crocker Mountain - June 10, 2019
- FOC Tips: Troubleshooting tips specific to Angle and Apex Offset - June 7, 2019
- Fiber Optic Center AskFOC: what are the most common issues regarding APC polishing geometry? - June 6, 2019
- FOC Tips: IL @ 1310 higher than 1550 - June 5, 2019