What happens if you have too much epoxy inside the ferrule holder?
Too much epoxy inside the ferrule holder can lead to other issues—for example, the inserted fibers will displace the injected epoxy so that it flows out the rear of the ferrule holder. This may cause epoxy to flow over the spring within a connector body, locking up the spring and creating a defective connector. However, these cases are observable / test-able after curing.
READ THE FULL BLOG ARTICLE HERE: The processes involved in Termination play a CRITICAL role in determining the long-term reliability of the product
Answered by AskFOC Technical Team August 24, 2018
Have a technical question for Fiber Optic Center?
Please email your question to AskFOC@focenter.com and we will respond ASAP.
In addition to replying, we will post your question and our answer here on the AskFOC page. Everyone remains anonymous when we post so feel comfortable asking your questions. You can also search to see if your question has already been answered in the FAQs section below.
- Fiber Optic Center AskFOC: Is there a real need for 3D printing polishing film beyond sandpaper? - September 25, 2018
- Fiber Optic Center AskFOC: how many categories are there for buffered fibers? - September 25, 2018
- FOC Tips: fiber stripping blades - September 24, 2018
- Fiber Optic Center AskFOC: where can I get some information on SMA connector over polishing? - September 21, 2018
- FOC Tips: SMA High Power application - September 20, 2018
- Fiber Optic Center AskFOC: which epoxies cause allergic reactions and which do not? - September 19, 2018
- FOC Tips: solutions for clean connections - September 17, 2018
- Fiber Optic Center AskFOC: how can I identify crystallization in epoxies? - September 14, 2018
- FOC Tips: Step one of single-fiber PC ferrules, developing a polishing process - September 13, 2018
- Fiber Optic Center AskFOC: what happens if you undermix epoxy? - September 11, 2018