There are a total of eight tips and considerations regarding freezing epoxy in FOC’s blog article, Ideas to adjust your epoxy process: Recommendations to reduce waste (and save money) in your fiber optic cable assembly process.
Here is an important one to highlight:
After fabricating the connectors or cable assemblies, the remaining material in the syringe must be frozen right away. A certain amount of pot life will have been used, and freezing does not further impact pot life. For example, if your epoxy’s pot life is 24 hours and you mixed and worked with it for 4 hours, then the unused material has a pot life of 20 hours.
READ THE FULL BLOG ARTICLE HERE: Ideas to adjust your epoxy process: Recommendations to reduce waste (and save money) in your fiber optic cable assembly process
Additional resources from the FOC team include:
- Category Resource FOC Epoxy Page
- Glossary, Acronyms, Military Specifications for Connectors: http://bit.ly/2a2EFn8
- Q&A Resource: email technical questions to AskFOC@focenter.com
Have questions about this FOC Tip?
Contact FOC with questions at: (800) 473-4237 / 508-992-6464 or email: FiberOpticCenter@focenter.com and we will respond ASAP.
- Aramid yarns and Good stripping techniques - September 11, 2019
- When the “back-side” connector end-face is contaminated, it is difficult to have access to remove the connector for cleaning - September 8, 2019
- Fiber Optic Cable Splicing Explained - September 7, 2019
- Ways in which the end-face can become contaminated along the way - September 6, 2019
- Removal of coatings from short fiber in certain sections - September 5, 2019
- End-face quality and cleanliness - September 4, 2019
- Re-cleaning a connector after installation - September 4, 2019
- The two wavelengths used for Insertion Loss testing - September 3, 2019
- Ensuring connector end-faces meet industry standards on end-face cleanliness (ex. IEC 61300-3-35) - September 2, 2019
- The “Ideal” Fiber Height for a Fiber Optic Connector – and How to Achieve It - August 31, 2019