Contamination on the fixture prevents ferrules from protruding equal distance from the base of the fixture.
This mainly applies to fixtures for polishing ferrule only (as opposed to connector polishing). The ferrules must protrude the same amount from the bottom of the fiber optic polishing fixture, to ensure consistent pressure being applied to all ferrules.
Contamination at the top of the bore, where the ferrule flange sits on, will cause the ferrules to sit higher and protrude less. If ferrules are protruding different length from the bottom of the fixture, this results in unequal pressures being applied to the ferrules during polishing, again resulting in variation in Radius values, FH values, and fiber end-face polish quality (scratches).
Additional resources from the FOC team include:
- Glossary, Acronyms, Military Specifications for Connectors: http://bit.ly/2a2EFn8
- Q&A Resource: email technical questions to AskFOC@focenter.com
- Contact FOC with questions at: (800) 473-4237 / 508-992-6464 or email: firstname.lastname@example.org
- Fiber Optic Center AskFOC: what are the different types of standards for MT/MPO measurements using interferometry? - November 15, 2018
- FOC Tips: Passive component tester configurations - November 13, 2018
- Fiber Optic Center AskFOC: how much is enough or the right amount of epoxy in the connector? - November 12, 2018
- FOC Tips: Step two of single-fiber PC ferrules, developing a polishing process - November 9, 2018
- Fiber Optic Center AskFOC: what causes the Apex of a radius to be imperfect, to be off-center? - November 8, 2018
- FOC Tips: Insertion Loss (IL) is the loss of power due to adding a jumper. - November 7, 2018
- FOC Tips: MT ferrule geometry measurements - November 5, 2018
- FOC Tips: contamination on the fixture prevents ferrules from protruding equal distance from the base of the fixture - November 2, 2018
- Fiber Optic Center AskFOC: how do we decide which passive component tester to purchase? - November 1, 2018
- FOC Tips: Fiber Optic Connector Cross Sectioning example from “Connector A” notes - October 30, 2018