The connector’s specifications dictate the quality of its performance and long-term reliability. That’s why it’s imperative to purchase high-quality connectors. Lower-quality connectors with lax tolerances can lead to optical performance issues such as high Insertion Loss, low Return Loss, and non-repeatable results. Lower-quality connectors can also invite a host of mechanical issues.
Whether you’re buying single mode connectors or multimode connectors, you want the best measurement tolerances possible for the following connector specifications:
- Ferrule hole diameter – The ferrule is arguably the most important component in a fiber optic connector. For minimum Insertion Loss, you should use the tightest-tolerance ferrule hole diameter available.
- Ferrule hole concentricity – The shape of the ferrule’s hole bore must be round. If not, you have ferrule hole eccentricity: an egg-shaped or oblong hole, which will not hold an optic fiber in perfect alignment and will degrade the performance of the connector. Ferrule hole concentricity is measured inside diameter to outside diameter (ID to OD).
- Ferrule hole to outside diameter (OD) – The hole in the ferrule must be perfectly centered. If not, the fiber it holds cannot be properly centered and aligned. This is why it’s important to purchase ferrules with exacting tolerances.
At Fiber Optic Center, Inc., we encourage our customers to purchase quality connectors that offer the tightest tolerances for ferrule hole diameter, ferrule hole concentricity, and ferrule hole to outside diameter. When your fiber optic cable assembly house uses connectors that meet stringent measurements tolerances, you are positioned to build world-class fiber optic cable assemblies that deliver performance and long-term reliability.
Additional resources from the FOC team include:
- Category Resource: FOC Interconnect Page
- Glossary, Acronyms, Military Specifications for Connectors: http://bit.ly/2a2EFn8
- Q&A Resource: email technical questions to AskFOC@focenter.com
Have questions about this FOC Tip?
Contact FOC with questions at: (800) 473-4237 / 508-992-6464 or email: FiberOpticCenter@focenter.com and we will respond ASAP.
- Key specifications of connectors - January 3, 2020
- Considerations regarding freezing epoxy – implementing process adjustment - December 16, 2019
- Considerations regarding freezing epoxy – THAWING - November 13, 2019
- Crystallization in Epoxies: How to Identify and Reverse it - October 23, 2019
- Measuring Insertion Loss and Return Loss Recommendations to Achieve the Best and Most Accurate Test Measurement - October 23, 2019
- Cross-Sectioning Fiber Optic Connectors: An Effective Diagnostic Method to Identify Defects and Resolve Process Issues - October 23, 2019
- The “Ideal” Fiber Height for a Fiber Optic Connector – and How to Achieve It - October 23, 2019
- Considerations regarding freezing epoxy – recommended length of time - October 23, 2019
- Techniques when using stripping tools - October 18, 2019
- Considerations regarding freezing epoxy – implementing process controls - September 18, 2019