When developing a polishing process, be sure to use only brand-new rubber polishing pads. Rubber pads play a critical role in polish results and are often overlooked.
Having a consistent hardness (durometer) across the surface of the rubber pad is CRITICAL in getting consistent polishing results. Rubber hardness will change over time, so rubber pads always need to be replaced periodically (once a year, at minimum).
READ THE FULL BLOG ARTICLE HERE: How to Develop a Fiber Optic Polishing Process that Produces Consistent Results
Additional resources from the FOC team include:
- Category Resource: FOC Polish Page
- Glossary, Acronyms, Military Specifications for Connectors: http://bit.ly/2a2EFn8
- Q&A Resource: email technical questions to AskFOC@focenter.com
Have questions about this FOC Tip?
Contact FOC with questions at: (800) 473-4237 / 508-992-6464 or email: FiberOpticCenter@focenter.com and we will respond ASAP.
- Aramid yarns and Good stripping techniques - September 11, 2019
- When the “back-side” connector end-face is contaminated, it is difficult to have access to remove the connector for cleaning - September 8, 2019
- Fiber Optic Cable Splicing Explained - September 7, 2019
- Ways in which the end-face can become contaminated along the way - September 6, 2019
- Removal of coatings from short fiber in certain sections - September 5, 2019
- End-face quality and cleanliness - September 4, 2019
- Re-cleaning a connector after installation - September 4, 2019
- The two wavelengths used for Insertion Loss testing - September 3, 2019
- Ensuring connector end-faces meet industry standards on end-face cleanliness (ex. IEC 61300-3-35) - September 2, 2019
- The “Ideal” Fiber Height for a Fiber Optic Connector – and How to Achieve It - August 31, 2019