Is a static mixer the recommendation for fiber optic epoxies?
Almost all epoxies used in fiber optics are two part and have dissimilar mix ratios. This, coupled with the relatively small amount of material being applied, means a static mixer is NOT a recommended way to go. There is too much risk of an incorrect mix ratio getting into the connector.
READ THE FULL BLOG ARTICLE HERE: Which Epoxy Packaging is Right for you?
ADDITIONAL CONTENT & RESOURCES:
- Category Resource: FOC Epoxy Page
- Find More Information in this Blog: Helpful Epoxy Tips (and a Few Tricks)
Answered by AskFOC Technical Team December 18, 2018
Have a technical question for Fiber Optic Center?
Please email your question to AskFOC@focenter.com and we will respond ASAP.
In addition to replying, we will post your question and our answer here on focenter.com. Everyone remains anonymous when we post so feel comfortable asking. You can also search your question and others in our content search.
- Considerations regarding freezing epoxy – THAWING - November 13, 2019
- Crystallization in Epoxies: How to Identify and Reverse it - October 23, 2019
- Measuring Insertion Loss and Return Loss Recommendations to Achieve the Best and Most Accurate Test Measurement - October 23, 2019
- Cross-Sectioning Fiber Optic Connectors: An Effective Diagnostic Method to Identify Defects and Resolve Process Issues - October 23, 2019
- The “Ideal” Fiber Height for a Fiber Optic Connector – and How to Achieve It - October 23, 2019
- Considerations regarding freezing epoxy – recommended length of time - October 23, 2019
- Techniques when using stripping tools - October 18, 2019
- Considerations regarding freezing epoxy – implementing process controls - September 18, 2019
- Aramid yarns and Good stripping techniques - September 11, 2019
- When the “back-side” connector end-face is contaminated, it is difficult to have access to remove the connector for cleaning - September 8, 2019