We have issues with crystallized epoxy: has the epoxy had “gone bad”?
This question has come up so often, I have written article to educate our customers about crystallization in epoxies including information on:
- How this happens.
- Why the epoxy is perfectly usable (it has not “gone bad”).
- How they can easily return the epoxy back to its clear, liquid form.
Crystallization in epoxies is such a common occurrence - hope you find the following answers and advice helpful!
READ THE FULL BLOG ARTICLE HERE: Crystallization in Epoxies: Steps for You to Spot it – and Fix It
ADDITIONAL CONTENT & RESOURCES:
- Category Resource: FOC Epoxy Page
- Find More Information in this Blog: Helpful Epoxy Tips (and a Few Tricks)
Answered by AskFOC Technical Team April 10, 2019
Have a technical question for Fiber Optic Center?
Please email your question to AskFOC@focenter.com and we will respond ASAP.
In addition to replying, we will post your question and our answer here on focenter.com. Everyone remains anonymous when we post so feel comfortable asking. You can also search your question and others in our content search.
- Techniques when using stripping tools - October 18, 2019
- Considerations regarding freezing epoxy – implementing process controls - September 18, 2019
- Aramid yarns and Good stripping techniques - September 11, 2019
- When the “back-side” connector end-face is contaminated, it is difficult to have access to remove the connector for cleaning - September 8, 2019
- Fiber Optic Cable Splicing Explained - September 7, 2019
- Ways in which the end-face can become contaminated along the way - September 6, 2019
- Removal of coatings from short fiber in certain sections - September 5, 2019
- End-face quality and cleanliness - September 4, 2019
- Re-cleaning a connector after installation - September 4, 2019
- The two wavelengths used for Insertion Loss testing - September 3, 2019